biofeedback device using pulse oximetry and temperature

$15-30 AUD / hour

Peruutettu

Julkaistu

yli 10 vuotta sitten

$15-30 AUD / hour

Firstly I need to know if this setup is possible. I hope to use this pulse ox chip by corscience; [login to view URL] data sheet; [login to view URL] I want to use this as a sensor for the chipox; [login to view URL] data sheet; [login to view URL] Will this sensor work with the chipox? I would like to connect 2 ChipOx boards up to an arduino nano. Is this possible? The second stage is to use 4 temperature sensors that connect to the arduino. This is the temp sensor I would like to use; [login to view URL] data sheet; [login to view URL] I am open to suggestions about the temp sensor. It is for measuring temp at four points along the forehead. I have looked at thermistors in the past but i think this chip will be more accurate.

Circuit Design

Electrical Engineering

Electronics

Medical

PCB Layout

Projektin tunnus (ID): 5415231

Tietoa projektista

6 ehdotukset

Etäprojekti

Aktiivinen 10 vuotta sitten

Haluatko ansaita rahaa?

Sähköpostiosoite

Freelancerin tarjouskilpailun edut

Aseta budjettisi ja aikataulu

Saa maksu työstäsi

Kuvaile ehdotustasi

Rekisteröinti ja töihin tarjoaminen on ilmaista

6 freelancerit tarjoavat keskimäärin $23 AUD/tunti tätä projektia

@waseemsangi

A proposal has not yet been provided

$25 AUD 1 päivässä

0,0

(0 arvostelua)

0,0

@pabasarak

Interesting project. Chipox has not mentioned about their sensors. So cannot comment whether the NJL5501R-TE1 will work with chipox. we can try to get their unit and revers engineer it.

$25 AUD 20 päivässä