ATmega128RFA1
$30-250 USD
Maksettu toimituksen yhteydessä
I would like someone to write a library to use the radio on the ATmega128RFA1 chip. Something that will let me setup network ID, channel, the device's ID, and baud rate... everything needed for simple communications right from the setup() function. Library should be as small as possible, and allow for end user to include, and use radio to communicate wirelessly with other ATmega128RFA1's in a mesh network.
I envision something that can be used from the Arduino IDE like so: (this may be an oversimplification)
#include
void setup(){
[login to view URL] = xxx;
[login to view URL] = xxx;
[login to view URL] = xxx;
}
void loop(){
[login to view URL]("blah blah blah");
delay(1000);
}
[login to view URL]
[login to view URL] - a similar circuit is being prototyped, and 2 will be supplied to winning bidder to test and debug library. Prototypes can be kept after project completion.
[login to view URL] - datasheet.
[login to view URL] - basic circuit
The prototype will only have In-Circuit Serial Programming (ICSP) header, so you will need your own programmer. Reason for needing library instead of using Bitcloud is so prototype can be used with Arduino IDE.
Projektin tunnus: #4020858
Tietoa projektista
9 freelanceria on tarjonnut keskimäärin $165 tähän työhön
Over 2 Years of RF Embedded Software programming experience ! And more than 8 years with Atmel MCUs !
We can do this at an affordable rate. We have over 5 years experience with Arduino projects.
We are freelance software developers. If you contact me I can give a quote for your project and we can discuss the details. <b><i>Removed by Admin</i></b>
We have done the software for Microchips's MRF24J40, we can probably do it for the Atmel's chip. They should be very similar, with 802.15.4.
