Development board for Compute Module 3
The purpose of this board is to enhance the feature of Raspberry pi Compute module 3. There is a usb hub to connect 4 usb at a time and HDMI connector with on board Lipo battery charger and voltage booster circuit.
Tietoa minusta
An Electronics engineer with experience of 6 years in design and development of Embedded and Power Electronics products. I have proficiency in following Software: 1. Keil/ATMEL Studio/MPLAB/ESP-IDF 2. MATLAB 3. Arduino IDE/Processing 4. Altium Designer/Eagle/Proteus/KiCAD 5. PLC/Citect SCADA/Visual IO/QT Hardware: 1. Any microcontroller, STM32, Arduino, Raspberry Pi, Beaglebone, Odroid, Banana Pi 2. ESP32,ESP8266 Wifi module, RF transceiver, GSM/GPRS Module, GPS, Bluetooth (nRF51822) 3. RFID, Fingerprint Sensor, Touch Keypad 4. Motion Sensor, Light Detector, Humidity Sensor, Gas Leakage Detector, IR Sensor, Ultrasonic Sensor, Accelerometer, Gyroscope 5. Hall sensor, Proximity, Encoder 6. Power Electronics Switches (SCRs, TRIACs, MOSFETs, IGBTs) 7. Thermocouple, RTD, Thermistor 8. Touch screen, Camera 9. Battery Charger Protocols: 1. SPI/I2S, I2C, UART(MODBUS), CAN, USB, Ethernet, SPDIF 2. HTTP, FTP, MQTT Platform: 1. Ubuntu, Debian, Raspbian, Arch Linux, FreeRTOS
