I had another freelancer create a 3d model of a figure for me, but when I sent it off to be printed, there were several areas of the design that were too thin. I just need you to be able to download this design (I will send you the 3D model) and fill it in so that it isn't hollow, and then thicken a couple areas. The printing company said it shouldn't take someone with knowledge on the subject more than a couple minutes.
Other than filling the design so that it is solid instead of hollow, I just need where the brim of the hat connects to the head to be a little bit thicker, and also I need where the zipper on the vest connects to the vest to be a little thicker on both sides. Finally, the vest overall just needs to be a bit thicker. The thinnest anything can be is about .05 inches.
Just a couple of quick fixes. The printing company said that, because it shouldn't take more than a few minutes, that $10 should cover it. AKA, I am not willing to pay more than 1 hour's work on this (a total of $10). I have included a couple pictures. One shows what the design looks like. The one with the red shows areas on the current model that are currently too thin (but would be fixed following my above instructions.)