Powershell network interface manager task

To run in the background monitoring network connections to:

Turn off specific WLAN radios if specific Ethernet is connected

Else turn on those radios

Connect to specific WLAN SSID if available, with minimum delay

Priority interfaces is Eth, Wi-Fi1, Wi-Fi2

Assign specific single static IPV4 to the highest priority interface that is connected and remove that IP from other interfaces if present.

So if there is no Eth enable radios and look for SSID. If found connect highest priority Wi-Fi interface to the SSID.

Once connected assign the IP to that one interface.

If Eth is then connected disable radios and assign IP to the Eth.

If Wi-Fi2 is connected and has the IP and Wi-Fi 1 interface is then connected disconnect Wi-Fi2, connect Wi-Fi1 and move the IP to Wi-Fi1.

As long as a connection is possible on any of the three interfaces it should be established on the highest priority and remain stable. If the active connection is lost, due to lost signal, cable disconnection, entering flight safe mode etc attempt connection on next lower priority interface with minimal delay.

Must run on Win7, 8, 10 32 and 64 bit

Solution need not be Powershell but WLANManager example could be a starting point.

[url removed, login to view]

Native support in stock Windows is preferred.

Taidot: Powershell

Näytä lisää: powershell set nic speed duplex, powershell set ip address windows 2012, powershell get network adapter settings, powershell new-netipaddress, powershell network adapter configuration, get-netadapteradvancedproperty, powershell set ip address static, powershell enable network adapter windows 7, network interface programming, setting network interface using, network interface card information, add network interface code, configure different network interface netbackup, java network interface count, low level network interface, network interface, network interface status, network interface card programming, ericsson network inventory manager light, hide manager task vb2005 vista

Tietoa työnantajasta:
( 0 arvostelua ) United Kingdom

Projektin tunnus: #16304356

5 freelanceria on tarjonnut keskimäärin %project_bid_stats_avg_sub_26% %project_currencyDetails_sign_sub_27% tähän työhön


A proposal has not yet been provided

£388 GBP 3 päivässä
(17 arvostelua)
£750 GBP 10 päivässä
(1 arvostelu)

Hi, I am ready to discuss this project and show demo (auto swith between ethernet and Wi-Fi after connection change).

£444 GBP 10 päivässä
(0 arvostelua)

Hi there, this sounds like an interesting project! It should be possible to handle this natively in Windows using PowerShell - so long as any client machines using this have PSv3 and above installed. I hadn't seen W Lisää

£500 GBP 10 päivässä
(0 arvostelua)
£400 GBP 10 päivässä
(0 arvostelua)