Suljettu

2 RGB cameras record directly to Micro SD-Card

I am wanting to have 2 separate RGB cameras that can record to a Micro SD-Card or if it will be easier to have each of them recording to separate Micro-SD Cards that will be fine. I am not 100% sure what else will be needed for this project. I am assuming a PCB board, Micro-Controllers etc. If it is possible to get a quote for all each camera using all three RGB connectors and a quote for just the yellow RGB connector that would be great! If the project is going to be over the $30 to $250 range we can set up goals to be accomplished and move forward from there.

Taidot: Piirilevyn asettelu, Elektroniikka, Mikrocontroller, Sähkötekniikka, Video Hardware

Näytä lisää: micro sd card manufacturers in india, can't delete files from micro sd card android, cut micro sd card, usb 3.0 micro sd card reader, how to change write protection on micro sd card linux, how to hack micro sd card, micro sd card tutorial arduino, micro sd card module arduino, micro sd card module nodemcu, micro sd card nodemcu, samsung micro sd card serial number, micro sd card problems, wireless micro sd card, read cid micro sd card, cracked micro sd card, how to recover deleted photos from micro sd card, samsung galaxy tab 2 10.1 micro sd card capacity, micro sd card showing wrong size, micro sd card interface with arduino, micro sd card case

Tietoa työnantajasta:
( 1 arvostelu ) Orem, United States

Projektin tunnus: #28397812

8 freelanceria on tarjonnut keskimäärin $385 tähän työhön

binyameen441

Hello, thank you for your job posting. I read your description about--2 RGB cameras record directly to Micro SD-Card I am a senior electrical engineer. I have plenty of experience in firmware development and micro-con Lisää

$40 USD 2 päivässä
(105 arvostelua)
6.4
(62 arvostelua)
7.0
avigupta0061

Best PCB Design Expert at your doorstep! Dear Client, We can do 2 separate RGB cameras that can record to a Micro SD-Card. We couldn’t stop ourselves from bidding after going through the description as they are an exa Lisää

$250 USD 2 päivässä
(16 arvostelua)
6.0
arifbilal75

Hello, I have checked your project description ..... I have good knowledge and experience in this field. I could do this job best and give you an outstanding result as you expect. I’m glad to answer any questions you Lisää

$70 USD 7 päivässä
(28 arvostelua)
4.7
nikitamorozzz

Hello, Dear. I am an electronic engineer and PCB designer. I am also automatic control expert. I have experience of designing video streaming module with STM32 in Drone. The task of module was to compress time serial R Lisää

$250 USD 7 päivässä
(16 arvostelua)
4.6
(20 arvostelua)
4.7
SACHINSMUNJI

Hello, I am Sachin from Bangalore work on Embedded Systems, PCB design, Schematics, layout design, fabrication service, components assembling, testing, PCB board services, etc. I work for development of POC, prototypes Lisää

$223 USD 5 päivässä
(0 arvostelua)
0.0
bezzemelnitr1

Hello, I have read your post carefully. I can implement your idea. I am a expert in PCB design. And also, I have good knowledge about camera DVR. These points will help you to be success. Thanks for your attention. Ren Lisää

$200 USD 5 päivässä
(0 arvostelua)
0.0