I built and LED matrix with WS2811 Through Hole leds.
My solder job was apparently not the best and there is an error (or multiple) within the matrix.
There are 4 leds from each LED. They are shown in the picture attached. From left to right, Data in, ground, 5v, data out.
The matrix is aligned so that the ground leads run to the top and 5v at the bottom. Data lines must be connected so there are wires running from the data out of one row into the next rows data in.
I need someone who knows soldering and can replace any dead leds and find any errors in my current wiring. I will supply the current matrix, an arduino that it runs off of and a bag of leds (if any need to be replaced).
I am also open to ideas about how to better complete this project the led matrix is curved and attached to a plexiglass panel that i had laser cut.
It needs to be see-through and has to be able to flex.
13 freelanceria on tarjonnut keskimäärin 157$ tähän työhön
Hi, I am Electronics engineer and has experience with circuit design. I can troubleshoot this problem and can redesign your PCB, feel free to contact me for this task.
Hello sir, have read your project very well you, am using eagle software, can send me message with more details, your and design we can discuss more about , if you're interested please send me message
Cheers, I've reviewed your scope of work and am confident I'm the man for the project. Feel free to contact me directly so we can start getting your Led matrix pushing the proper electrons? Joseph M. Pendleton