Käynnissä

Act-M50 Regenerative Motor Driver

The ACT-M50 can supply a single DC brushed motor with up to 50A continuously. Peak currents of 100A are achievable for a few seconds.

Overcurrent and thermal protection means you'll never have to worry about killing the driver with accidental stalls or by hooking up too big a motor.

With just one driver you can control a motor with: Analog voltage, Radio control, Serial and packetized serial.

The operating mode is set with the onboard DIP switches so there are no jumpers to lose. It has screw terminal connectors - making it possible for you to build without even soldering.

It is synchronous regenerative motor driver in its class. The regenerative topology means that your batteries get recharged whenever you command your robot to slow down or reverse. Its also allows you to make very fast stops and reverses - giving your robot a quick and nimble edge.

It has a built in 5V BEC that can provide power to a microcontroller or R/C receiver. The lithium cutoff mode allows ACT-M50 to operate safely with lithium ion and lithium polymer battery packs - the highest energy density batteries available.

ACT-M50 transistors are switched at ultrasonic speeds (32kHz), meaning no one will be able to hear your robot ninja army approaching.

Use of ACT-M50 motor drivers with cheap AC adapters is not recommended. Use a battery or at least put a battery in parallel with a DC supply.

Input Voltage – 6V-30V DC

Output Current – 50A

Peak Output Current – 100A

Operating Mode – Analog, R/C, Serial

Taidot: Mekatroniikka, Mikrocontroller

Näytä lisää: syren 10 a, sabertooth 2x32 troubleshooting, what is a regenerative motor driver, dual 32a motor driver, saber motor controller, sabertooth 2x25 dual arduino, sabertooth 2 25 motor controller, syren motor driver tutorial, buying regenerative motor controller, phase motor driver, best buys stepper motor driver, regenerative motor braking, stepper motor driver, motor driver code, phase regenerative motor driver, amp stepper motor driver, bipolar step motor driver cnc project, building stepper motor driver, cheap stepper motor driver, dc motor driver board feedback

Tietoa työnantajasta:
( 0 arvostelua ) Chandigarh, India

Projektin tunnus: #27506776

Myönnetty käyttäjälle:

(40 Arvostelua)
5.2