ANSYS_based_ANALYSIS
Budjetti ₹1500-2500 INR
Modelling the Effect of voids on mechanical and thermomechanical properties of short and long fibre composites ) - Need Numerical analysis by ansys ?
To solve it by ansys... Basically , we need to consider one short fibre bio-based composite and one long fibre bio-based composites.. we need to consider void content percentage in that - 1% , 2%, 2.5% , 5%, 10%, 20%. After considering void percentage we need to find out how these voids will effect some of the mechanical properties and some of the thermo-mechanical properties . We need to give simulation results. Thats it really. Please let me know if this is possible , cost and how much time you need forI am just asking simulation result. You dont need to do any report or something like that.. just screenshots of results i need with the input data and boundary conditions this.
14 freelanceria on tarjonnut keskimäärin ₹11646 tähän työhön
Hi, My name is Ishwar, I am a Mechanical Engineer with many years of experience using FEA and CAD tools. I can do the analysis and send you the results Please open a chat so that we can discuss it more. I will do my Lisää
Hi, I hope you are doing fine. I have PhD in mechanical engineering from Tohoku University of Japan. I have published 20 Journal papers and 16 international conference papers. I have a lot of experience in automotive, Lisää
Hi I have read and understood the latitude of the project, allow me to assist you in simulation. Warm regards
Hello, I checked desciprition so we have to do STATIC STURTURAL AND STEADY STATE THERMAL ANALYSIS. I WILL PROVIDE THIS IN ANSYS. can you share boundary conditions and load Lisää
hello iam amechanical engineer with more than 5 years experience, iam expert in ansys and I did many tasks like this before, please contact me for details
I have done micro mechanical analysis estimating mechanical properties of fibrous composite materials. Hope I can wind off the mechanical for short fibers too.
I have just completed my 3rd 1Sem of mechanical engineering, so I have fresh knowledge about the software and on top of that I think new people should be given chance to prove their worth and to know themselves where t Lisää
