Need small scale manufacturing of percussion practice pads. The practice pad consists of an approximately 3/4" thick octagonal plywood sheet that is 12" in width. The edges of the plywood sheet need to be beveled or smoothed down in some manner. A soft gum rubber sheet is glued onto one side, creating the playing surface. A sheet of a possibly more cost-effective, non-slip rubber is glued to the other side to create the base of the practice pad. There should be a gap of approximately 1/2" between the edges of the rubber sheets and the edges of the plywood. The image attached is very similar to what is described above. The red part of the practice pad is the gum rubber while the black middle section is the plywood, and the bottom layer is the non-slip rubber. In our case, the gum rubber will preferably be cream or tan in color, the plywood a natural finish, and the bottom side black. We are looking for a manufacturing sample followed by an initial test batch, with the possibility of continual reorder. Thank you.
9 freelanceria on tarjonnut keskimäärin 400 $ tähän työhön
Industrial Designer. I volunteer in a NGO (non-governmental organization) that teaches music to kids that are up from 13 years old, so I have contact with drums knoledge.