4 simple JPG Images required for a toothbrush

The L- Brush

Due: 16/03/2009

Images required: 4

Size of Images: Atleast 800 X 800

Quality: High

Dimensions: Negotiable (If you bid, please let us know if you will draw the images in 3d or 2d)

Format: JPG (If you will use photoshop the original file would be very useful)


Technical details

1-Diagram A shows the exterior view of the tooth brush.

2-The size of the tooth brush should be similar to the size of the electric tooth brushes.

3-It has two round buttons one at the front (button 1), and the other at the back (button 2).

4-The two buttons are actually pumps.

5-The brush head (diagram C) fits on the brush just like a pen cap.

6-There are small holes in the back of the brush head (point B), which are linked to a tube that acts like a pump, this tube (tube 2) is linked to the round button at the back (button 2).

7-The brush head has one medium sized hole at the front, see diagram (point A). This hole is connected by a tube (tube 1) to the button in the front of the tooth brush (button 1).

8-The base of the tooth brush opens like a bottle cap.

9-Tubes 1 should be thin from the top, until they reach the neck of the tooth brush from (T1-T2), and then from (T2-T3) the tube becomes much wider. Finally, (T3) is connected to button (1).

10-The same as the previous point but, Tube 2 should be thin from (T4-T5), the tube then becomes wider from (T5-T6), and finally (T6) is connected to (button 2).

11-The brush has a small logo on the side. The logo is ( L-Brush)


Note: Please only bid if you are confident that you will not be late. Any late submission will render this project a faliure for me.

Taidot: graafinen suunnittelu, Photoshop

Näytä lisää: photoshop toothbrush, simple toothbrush diagram, tooth brush photoshop, top 10 photoshop images, tooth design logo, simple 3d draw, simple 3d design, photoshop me thin, photoshop brush for logo design, pen design, logo render, logo design tooth, logo design brushes, images by design, graphic design pen, graphic design brushes, draw it for me, design 3d logo photoshop, design 3d bottle render, cap design logo, brush logo design, brushes for logo design, 3d simple, 3d render bottle, 3d logo design in photoshop

Tietoa työnantajasta:
( 5 arvostelua ) oxford, United Kingdom

Projektin tunnus: #397031

Myönnetty käyttäjälle:


please check pmb

$50 USD 2 päivässä
(29 Arvostelua)