I need to perform mixing simulation in a small cylindrical vessel which has rotating axial blades. The mixing is emulsified water, surfactant and mill base - basically homogenisation.
the analysis needs to be done in OpenFOAM, I need the setup and will run the simulation on my workstation.
I will be providing fluent mesh as per your expectations along with required parameters.
Let me know if you have any questions.
You can also use Ansys for meshing purpose only - the remaining setup and solution has to be compulsorily in OpenFOAM.
I will provide geometry for you to use in this case.
16 freelanceria on tarjonnut keskimäärin 519 $ tähän työhön
I am currently working as a CFD engineer in an organization and I can perform meshing of complex parts. I have asked 3 weeks time to test the setup in OpenFOAM and to make sure it will be running at your end.