FPGA designer using VHDL and/or Verilog for Xilinx and/or Altera FPGA(s)
$30-250 USD
Suljettu
Julkaistu lähes 6 vuotta sitten
$30-250 USD
Maksettu toimituksen yhteydessä
Design a 3-phase 500Hz FPGA based generator driving a quad-channel DAC (only 3 channels needed) such as the LTC 2624.
The overall idea is that; following <RESET> a table of values representing a sine wave shall be stored internally and scan sequentially by the three output stages in a manner that each output is 120 degrees off-phase with each other as shown in the attached image. No other work is needed at this point.
I will provide a Xilinx Spartan III demo board made by Digilent ([login to view URL]), if necessary and have it shipped to the developer. The developer is welcome to keep the board.
Dear sir
I already have the same board, u dont have to buy it and send it to me.
have more than 10 years experience in digital design using FPGA, i can make this design and assist u to run it , please check my profile, also please message me so that we can discuss.
Best regards
Hey i can design in both xilinx for spartan kits and Quartus for Altera FPGA, through i am fresh i dont havw reviews... But i can gauretee of perfection in my work..
I am an Electronics and Communication Engineer with a keen interest in Digital Design. I have done several projects on Verilog and VHDL. I feel I will be fit for this project since I have already worked on ADCs using FPGA before. I can share my Resume for reference if required.
I have thoroughly read your project and fully understands your requirements. I am an Electronics Engineer with vast experience in Xilinx Spartan III. I have made many projects on Xilinx Spartan III and you donot need to send the board. I am ready to work on this project and waiting for your reply to futher discuss the project.
Thanks.