We need a pcb design (RoHS) for a a PoE-receiver-pcb with power supply and led driver.
This PoE-receiver would be connected to an single-board-camera-module ("camera-pcb").
This pcb receives via PoE-Lan cable a +48V signal with 100Mbit/s ethernet and should to serve via solder pads:
* 100 Mbit/s ethernet
* 12V power supply with minimum 200mA
* Status LED Port (signal comes from the camera-pcb)
* Power LED Port (signal comes from the camera-pcb)
* Photo Diode + Port (signal goes to the camera-pcb)
Please see attached PDF for further informations.