I need a small size arduino with only D2 D3 D4 D5 pins holes.
Need to be able to upload code trough the programming pins holes. Also need A4 A5, GND VCC holes. Make with less components than regular arduino board.
Board size around 40x30mm
Power 5volt 16mhz
I dont know what is best to use a crystal or a resonator .
So long the unit works, it will be the same for me.
I have done this project many times and all, ALL where NON working units after payment was done. IF YOU CAN DO THIS PROJECT, PLEASE BID! If not, dont bid!
IT IS an requirement that it MUST be done in easyeda
[login to view URL]
10 freelanceria on tarjonnut keskimäärin 68$ tähän työhön
Hello, I have been using Arduinos and Atmega chips in my projects for years. It is possible to make it much smaller than you state also. I look forward to hearing from you. Kind regards, Hugo
Dear sir, I am an electrical engineer... I have much experience in aurdino and coding of aurdino.. I can do your project... please come a chat to discuss it.. Thanks