Build me a decoder for the PT2264 on a AtXmega

I have a board that I designed using an Atxmega128A1U microprocessor from Atmel. I want to use a remote control that uses a PT2264 chip to encode an address and a 4-bit data code referencing which button on the remote was pressed. I want a driver/code that I can add to my design that implements the decoder circuit for the PT2264 chip. The code should monitor the pin that interfaces with the digitized signal and provide the address and data when it receives a valid signal from the remote. A valid signal is a sync pulse followed by the address and data.

I've attached the datasheet for the PT2264 and a snapshot of the transmission from the PT2264 using a logic analyzer. The logic analyzer snapshot represents the code 1FFFFFFF0001. 0001 is the data and 1FFFFFFF is the address.

This project is using the same remote system as the rc-switch library for the Arduino 433Mhz receiver. The coding scheme is the same but directly it doesn't run on the Xmega.

I'm currently running the Xmega at 32Mhz but will probably move that down to 2Mhz to lower the power consumption. The driver should be able to handle either processor speed.

Taidot: Arduino, sähkötekniikka, elektroniikka, Mikrocontroller

Näytä lisää: atmega328 ir receiver, ir library for atmega8, arduino ir remote decoder, avr ir remote control, avr ir library, avr rc5, rc5 decoder with avr atmega8, ir remote receiver c source code, Design/Build-Website-13946298 see if this helps., We need to build a new design for this entire page (one single page): https://www.checkthem.com/reverse-phone/ - Their current , Build a Website - Androidqa2chris - Test This On Projects With My Skills, Build a Website - Androidqa2chris - Test This On Projects With My Skills 1, speed wind using arduino, arduino web switch state, x10 arduino control switch, arduino wirelessly switch light, arduino relay switch, arduino web switch, arduino electrical switch, arduino lights switch

Tietoa työnantajasta:
( 0 arvostelua ) ARVADA, United States

Projektin tunnus: #17114898

Myönnetty käyttäjälle:


Hi, dear! I saw your project. I am a interested in your remote control project. I can do it and i wold like to discuss the details. I will best. Thank you.

$155 USD 3 päivässä
(37 Arvostelua)

5 freelanceria on tarjonnut keskimäärin %project_bid_stats_avg_sub_26% %project_currencyDetails_sign_sub_27% tähän työhön

$155 USD 3 päivässä
(9 arvostelua)

Hello I would like to help with your driver. I can develop a modular driver that you can use in any architecture. We can define if will work in a single thread or using an OS (I recommend this last one) Howeve Lisää

$177 USD 5 päivässä
(6 arvostelua)

I have been working with atmel uControllers for many years now and would love to be able to help you. Regards, Shah

$222 USD 10 päivässä
(0 arvostelua)

hi there I have read your description. I have done your project before. But you have connect the input pins of PT2264 chip to the Atxmega128A1U microprocessor analog pin. For eetails we can disscuss in chat. Feel Lisää

$50 USD 3 päivässä
(1 arvostelu)