SMT32 microcontroller firmware programming

Please read text project.

I use ST microcontroller STM32F103 and STP16CPC26XTR (16 channels led driver controller)

The software can receive information via RS485 (serial port) and CAN BUS. You can receive 5 frames:

Left Text (5 ASCII char) (5 bytes)

Right Text (5 ASCIIchar) (5 bytes)

State of linear bar, state of curved bar and state of arrows and central LEDs (2 Bytes)

Brightness level (1 Byte). General Adjust PWM (10 steps 10%-100%)

State requirement. Returns the model and serial number (2 Bytes).

CAN BUS Frames is similar but on canbus interfase.


Microcontroller programming. Send source code.

Taidot: Arduino, C-ohjelmointi, sähkötekniikka, elektroniikka, Mikrocontroller

Näytä lisää: phone firmware programming, cell phone firmware programming, pic microcontroller visual programming, stm32 tutorial, stm32 programming software, stm32 microcontroller datasheet, stm32 microcontroller programming, stm32 programming, stm32 datasheet, st microcontroller, stm32 ide, mobile phone firmware programming, microcontroller firmware development, microcontroller firmware medical devices, firmware programming arm9, microcontroller dsp programming india, firmware programming project, linux firmware programming, firmware programming, freelance firmware programming

Tietoa työnantajasta:
( 23 arvostelua ) sargodha, Pakistan

Projektin tunnus: #17396682

7 freelanceria on tarjonnut keskimäärin %project_bid_stats_avg_sub_26% %project_currencyDetails_sign_sub_27% tähän työhön


Hello, I have read the details of your job, and I am able to deliver it. Please contact me so that we can discuss the details.

$222 AUD 1 päivässä
(42 arvostelua)

I have long experience with 8-bit , 16-bit and 32-bit micro-controllers. I work with Microchip (PIC) , Atmel (AVR , SAM) , ST (STM) , TI (MSP) and NXP (LPC) micro-controllers. I use KEIL IDE , Atmel Studio , Code Compo Lisää

$25 AUD 1 päivässä
(19 arvostelua)

I would need the circuit schematic and operation details, and then provide ARM assembler firmware to do what is required (source and binaries). Will probably require 3 or 4 iterations after you load & debug on your pr Lisää

$111 AUD 3 päivässä
(1 arvostelu)

Hello, I am electronics engineer with rich experience on microcontrollers and embedded systems. I have depth knowledge in C and C++. I am looking forward to work on this project. Regards, Blaž Mandl

$166 AUD 14 päivässä
(1 arvostelu)

Hi, Hope you are doing good. Ping me if you are ok to work with me.

$20 AUD 2 päivässä
(0 arvostelua)
$30 AUD 2 päivässä
(0 arvostelua)

stm32 L4 ,F1,F4 driver development many years stm32 L4 ,F1,F4 driver development many years stm32 L4 ,F1,F4 driver development many years UART I2C SPI driver development

$25 AUD 1 päivässä
(0 arvostelua)