Suljettu

review of arduino firmware 3D printer (Marlin) -- 2

I have a finalized firmware for a 3d printer Juts need to get a small problem Im having with the heated bed and heaters fixed. should not take more than an hour to fix for someone with knowledge.

checked the wiring and hardware and they are all fine. please apply if you have experience with 3D printers, experience with Marlin firmware is a plus!

Taidot: 3D-tulostaminen, Arduino, C-ohjelmointi

Näytä lisää: get arduino

Tietoa työnantajasta:
( 12 arvostelua ) Wellington, United States

Projektin tunnus: #9972968

8 freelanceria on tarjonnut keskimäärin %project_bid_stats_avg_sub_26% %project_currencyDetails_sign_sub_27% tähän työhön

VoblNet

Hello. I can do it. .

$250 USD 15 päivässä
(19 arvostelua)
5.8
acarloss

Hi, I have several years of advanced experience in Arduino development and 15+ years in electronics/embedded development. I also have experience in 3D printing and 3D printers, I have made my own Prusa i3 almost Lisää

$150 USD 10 päivässä
(23 arvostelua)
5.5
hazemhaiba

Hello there , i just finshed making my 3d printer from scratch a month ago and im printing very cool stuff now i can send u pics if you like, although im using reptier firmware, i will still fix this for you ;) give me Lisää

$30 USD 1 päivässä
(4 arvostelua)
1.9
$35 USD 0 päivässä
(1 arvostelu)
1.3
jeremysiedzik

Hello, I have built a number of projects with the Atmel chip set, on Arduino boards and simply on their own. I have my IDE setup with a ton of extras. I've built a few 3D printers and I have some familiarity with th Lisää

$155 USD 3 päivässä
(0 arvostelua)
0.0
FrankTWR

Hi, Sorry to hear you're having an issue. Before blaming the firmware, check the green wiring block on your Ramps board and see if their is any melting of the green connector. This would especially appear on the far Lisää

$35 USD 1 päivässä
(0 arvostelua)
0.0
karanbal

can be done fairly easily, will need some info about what type of temp sensor you use, and a few basic stuff. I have been working on Marlin (3d printers) for quite a while (2.5 yrs).

$100 USD 3 päivässä
(0 arvostelua)
0.0
$100 USD 3 päivässä
(0 arvostelua)
0.0