Need Professional Firmware Engineer to make ELD Device

Suljettu Julkaistu 2 kuukautta sitten Maksettu toimituksen yhteydessä
Suljettu Maksettu toimituksen yhteydessä

I am seeking a professional firmware engineer to help me create an ELD (Electronic Logging Device) with customizable options based on specific requirements.

J1939 device specifications

- WiFi 801.11b/g/n up to 150Mbps and simultaneous AP and Station modes

- Bluetooth 4.2 Class 1 supporting BR/EDR and LE dual-mode

- Multi-constellation GNSS receiver with built-in high-gain antenna

- High-efficiency switching power supplies for low temperature operation

- Over-, under-, and reverse-voltage protection exceeding automotive standards

- ESD protection exceeding automotive standards

- Full-color RGB LED for status indication

- Dual-core 32-bit Tensilica processor at 240MHz

- Built-in J1939 Type II 9-pin connector supporting both new and legacy vehicles

- Physical layer and protocol auto-detection/auto-bauding

- Dual-wire CAN interface supporting 1Mbps

- Dual-wire J1708 interface

- J1939 protocol support

- ISO 15765 and ISO 14229 (OBD-II) protocol support

- J1587 protocol support

- Built-in flash memory

- Support for ELD APIs for Android and iOS

- Support for Advanced Vehicle Parameter Database


- I already have a specific model in mind for the ELD device.


- The project needs to be completed within 20 days.

Ideal Skills and Experience:

- Strong expertise in firmware engineering.

- Familiarity with ELD regulations and requirements.

- Ability to work within tight timelines to deliver high-quality results.

If you have the skills and experience required for this project, please reach out to me with your portfolio and relevant experience.

***NOTE: Freshers do not bid***

Need an experienced firmware engineer

Bluetooth Low Energy (BLE) Mikrocontroller Sähkötekniikka Firmware Piirilevyn asettelu

Projektin tunnus: #37525004

Tietoa projektista

4 ehdotusta Etäprojekti Aktiivinen kuukausi sitten

4 freelanceria on tarjonnut keskimäärin ₹55938 tähän työhön


We have a ELD device already built which meets most of the points mentioned here. Some of the standards and protocols need further investigations. Will look into all that only if some serious interest is shown. Our des Lisää

₹56250 INR 7 päivässä
(2 arvostelua)

Hello, my name is Adnan Gohar and I am an experienced professional with a strong background in firmware engineering. I am highly skilled in electrical engineering, microcontroller, PCB layout, and other relevant fields Lisää

₹56250 INR 7 päivässä
(7 arvostelua)

As I write this, I hope all is good with you. I'm Shubham Pandey, an incredibly skilled embedded software engineer with over seven years of expertise. I'm excited about the possibility of working with you to make your Lisää

₹56250 INR 30 päivässä
(0 arvostelua)