Arduino with TDC GP21

An Arduino with Atmega 328 controls an eval Kit GP21 by acam.

The TDC is controlled via SPI.

The digital timing is done for a start and stop signal with rising edge.

TDC-MRange2, single hit, 1Start, 1Stop, digital input

Data output via RS232 or USB (Arduino)

Permanently, the processor generates a start pulse at a distance of 1 ms. The stop signal (TTL) reaches 10us 3 µs later. The eval-Kit GP21 by acam is the standard application of the TDC. Register of all configurations are known. The mode of operation is continuous.

The datenausgabe is carried out continuously.

All program data is on the Web site of acam.

As a milestone, a code to write is agreed the configurations register and the reading of the result register.

The code must be compiled. The mode of operation single measurement.

The test of the program takes place with a real TDC. The result of the TDC must be read with a standard terminal program via RS232 or USB and verifiable.

The end result of the project is a continuous operation mode. The rate of measure is 1 or 10 kHz. The measured values are continuously issued as moving average of 1000 measurements.

The program language bascom or Arduino. When programmed in C, the Arduino code must run.

A real time measurement shall operate as a milestone.

The payment is done via pay pal.

Taidot: Arduino

Näytä lisää: tdc gp21, arduino gp21, tdc gp21 spi, arduino tdc, output data gp21, tdc gp21 measurement, tdc, arduino tdc gp21, arduino acam tdc, timing processor, acam arduino, rs232, code arduino, Arduino, Arduino code, arduino arduino, usb data read program, arduino code ttl, usb rs232 project, acam tdc, arduino read spi, digital signal via, usb spi, code arduino program, rs232 input

Tietoa työnantajasta:
( 0 arvostelua ) Germany

Projektin tunnus: #4227359

3 freelanceria on tarjonnut keskimäärin %project_bid_stats_avg_sub_26% %project_currencyDetails_sign_sub_27% tähän työhön


Hi, do you need a professional help?

$200 USD 2 päivässä
(2 arvostelua)

Hi there i can do it.

$250 USD 20 päivässä
(1 arvostelu)

Hello, I am well experienced in Ardiuno with SPI communication. I can do this project for you. :)

$200 USD 14 päivässä
(3 arvostelua)

Dear Sir, We are Reserach and Development company whose working area are : -Digital Motor Control -Analog Design -Electronic Design -Power Electronics -PCB design -Embedded system -Matlab -Simulation of ha Lisää

$200 USD 5 päivässä
(1 arvostelu)