Single-Zone Split AC Installation

@lisap586

Hello, I am a licensed air conditioning installer who will complete your split‑system setup in one visit. I will mount the indoor unit, seal the wall penetration, anchor the outdoor unit with anti‑vibration pads, and route all refrigerant lines, drain, and cables through the existing passage. Using a nitrogen bottle and vacuum pump, I will perform a full leak test and deep vacuum to below 500 microns, then open the service valves (or charge the system if it came with a dry nitrogen holding charge). I will tighten all flare connections with a torque wrench to exact manufacturer specs to prevent future leaks. After connecting to your dedicated electrical circuit and checking earthing, I will power on the system, test all operating modes, measure temperature drop across the indoor coil, and show you how to use the remote controller and any optional smart features. I will clean up all debris, packaging, and drilling dust before leaving. I have installed over 200 split AC units in residential settings, and I guarantee your system will run cool, quietly, and efficiently after my work. Best regards.