Microcontroller Programming (STM32 / ESP32) Jobs

Suodata

Viimeisimmät hakuni
Suodatusperuste:
Budjetti
asti
asti
asti
Tyyppi
Taidot
Kielet
    Työn tila
    2 löydetyt työt

    我计划对苹果电池进行循环次数与寿命参数的深度调整,因此急需一套完整的 7037 IC 芯片烧录方案。 核心需求 • 针对 7037 IC 编写全新的烧录程序(目前手上没有任何现成代码)。 • 在烧录过程中,能够修改电池循环次数、寿命计数等关键寄存器 / 参数。 • 保证方案可兼容常见苹果电池型号与主流编程器,避免版本差异导致的写入失败。 交付内容 1. 技术文档:逐步说明硬件连接、指令集、寄存器说明及烧录流程。 2. 源代码:可直接在指定编程器上运行的烧录脚本 / 固件。 3. 修改指引:解释各参数对应的电池表现,并给出推荐数值区间。 4. 兼容性说明:列出已验证的电池型号、固件版本与风险点。 我拥有必要的测试平台,可在收到资料后第一时间验证;如能提供示范视频或截图,将大幅缩短确认周期。期待与熟悉电池管理芯片、逆向或固件开发的工程师合作。

    €12937 Average bid
    €12937 Keskimäär. tarjous
    3 tarjoukset

    My ESP32 Dev Module refuses to return anything when I send AT commands to a SIM800L red board. The wiring follows the usual guides: GPIO27 to the SIM’s RX, GPIO26 to its TX, grounds tied together, the SIM powered directly from a single 18650 cell. I’ve triple-checked every jumper and even dropped a 1 kΩ resistor on GPIO27 and a 2200 µF capacitor across the SIM’s Vcc–GND rails—still silence. I’m compiling the sketch for the standard “ESP32 Dev Module” target in the Arduino IDE and the board is on a direct USB cable to my laptop. Serial monitor shows the commands leaving but not a single character coming back. If you know this pairing well, I’m looking for hands-on guidance that quickly pinpoints what I have overlooked&mdash...

    €6 Average bid
    €6 Keskimäär. tarjous
    12 tarjoukset

    Sinulle suositellut artikkelit