|SPICE circuit design of DC powerline communication circuit
||We want to a SPICE circuit design for simple, low data rate, DC powerline communications;
- 12 to 120 VDC (<5 amps)
- just 2 wires carry both power AND comms
- not twisted pair wires
- 100m cable runs
- low baud rates (9600 would be great!)
- low noise rural environment
- we'll use a protocol like NMEA - that repeats sentences... so lost data/sentences are OK
- happy to re...
||elektroniikka, sähkötekniikka, Piirilevyn asettelu, Arduino, Piirisuunnittelu
||Sep 15, 2017
||Sep 15, 2017Loppunut
|Hire a Software Developer
||Skill Requirements: GPS, C++ Programming with GPS NEMA String GGA, GLL, GSA, GSV, RMC, VTG
Project Scope: Need to modify the program from a UBLOX to an NEO-M8U need to adjust the program to Make the NMEA string work with the NEO-M8U Chip. Submitted the changes in “Red” C++ program and the HEX file to be tested. Just need the HEX file to be tested and confirm it works.
Part 1: Mod...
||C++ -ohjelmointi, GPS, Ohjelmistokehitys
||Aug 16, 2017
||Aug 16, 2017Loppunut
||VERY simple project to code (provide code only and a simple pin wiring diagram)
that will log GPS positions with correct time to an SD card. You don't need to buy the hardware, i can test the code on my hardware. Listed below.
There are lots of examples of code out there that do all this already, but i just need it pulled together to work in one final full sketch (IDE code) so i can compi...
||Aug 9, 2017
||Aug 9, 2017Loppunut
|GPS RF Data link
||I require a low power (100mw) 433mhz Tx/Rx to transmit GPS NMEA data and barometric pressure data to a ground receiver. Ground receiver to be fitted with Bluetooth or WiFi to connect with tablet device (iPad or Android). 2 hz refresh rate is adequate. Prototype and then small scale production.
||Jun 1, 2017
||Jun 1, 2017Loppunut
|Design an NMEA2000 interface PCB
||This project is to ultimately create an NMEA interface board that will take signals from a boat Rev Counter, Temperate, Pressure, Fuel level, Leg Position.
Ideally a single product that can be programmed to be configured to take any of the signals. Possible that one product be designed that takes all of them as one.
The first stage of the project is to look at feasibility and material cost...
||elektroniikka, Piirilevyn asettelu
||Apr 2, 2017
||Apr 2, 2017Loppunut
|Embedded system firmware design.
||Familiarity with TI Tiva and MSP430. TI-RTOS. Nordic nRF52.
LCD display, CAN Bus/NMEA 2000, Bluetooth, IOS.
||Mar 8, 2017
||Mar 8, 2017Loppunut
|Write some Software
||create an application in windowsCEbased device to capture the data incoming from a serial port and sort/delimit and display in vaious textbox as per the NMEA string header
||Mar 8, 2017
||Mar 8, 2017Loppunut
|Hire a Python Developer
||I'm needing a program (preferably python) that can take input from 2 GPS's and perform position calculations and output NMEA sentences. Should have the smarts to combine GPS's of both are in RTK fix or pick best and use it if both are not RTK.
read data from 2 GPS's simultaneously
User selective for TCP/IP, USB or Bluetooth
Decide which is best quality (or bot...
||Mar 6, 2017
||Mar 6, 2017Loppunut
|I would like to hire an Electronics Engineer
||I have problem with depth finder, I also need help to set up depth finder, log etc. with GPS nmea system. All instruments are on my 30ft sail boat.
||Feb 18, 2017
||Feb 18, 2017Loppunut
|Speed control with OpenStreetMap
||I need a function with this header:
function get_speed (several parameters from NMEA data attached image, &$min_speed, &$max_speed, &$speed_between_allowed_range);
This function should use the latitude, longitude, speed received, and the rest of the data from NMEA frame and check if it's right according with the max allowed speed in the road with latitude and longitude.
||Jan 28, 2017
||Jan 28, 2017Loppunut
|Data acquisition software development
||I need you to develop some software for me. I would like this software to be developed for Windows using C or C++. Windows based software is required. Software may be developed using Labview or C#. Software will be used for Automotive Performance Tests.
• Software should acquire data from GPS unit with NMEA format.
• GPS will be connected using USB.
• Software should log and save ...
||C-ohjelmointi, Windows Desktop, tietojärjestelmäarkkitehtuuri, C++ -ohjelmointi
||Dec 12, 2016
||Dec 12, 2016Loppunut
|Raspberry Pi Python script (GPS Beacon)
||I need a python script to run on a raspberry pi.
Pi will have a GPS module attached to GPIO UART.
It is UP501 (standard NMEA output @ 9600bps)
I need python script to send UDP packet to online server every time a NMEA sentence is received. You must parse the sentence and extract the following:
Position (GPS coordinates)
Then send this data in a single UDP packet to...
||Jul 24, 2016
||Jul 24, 2016Loppunut
Check [osoite poistettu, kirjaudu sisään nähdäksesi] for an example of the single line calculator
||May 31, 2016
||May 31, 2016Loppunut
|Matlab - NMEA data
||Reading GPS data --NMEA format from file
I am looking for Matlab expert to do the following easy job. Simply; I am looking for application read data from file then plot the result on figure (jebg file).
1. I got function from the internet can read the data line by line. This function will save 80% of the job. Will sure it once we agree on the job. Your task will by use this function ...
||Matlab ja Mathematica
||May 1, 2016
||May 1, 2016Loppunut
|GPS nased navigation and tracking software offline maps
||Write a Software for GPS position location, with multiple GPS input. The Data input is by USB, each line has full NMEA data with a unique identifier. The sofware should be avle to filter the data based on unique identifier. Then plot it on a map, offline over a Map, map format is ECW of a scanned map that can be calibrated.
On map display option to select master GPS data and show all other GPS ...
||Apr 21, 2016
||Apr 21, 2016Loppunut
||Should have familiarity with the TRACCAR, in order to modify this open-sourced software.
We have many mobile routers which transmit GPS data (NMEA $GPRMC) to a remote server. This router is configured to send data to an <IP address> : <port>.
We need a web GPS service that is able to:
1. Open the <IP address> : <port> to accept connections (Note : our routers transm...
||Mar 24, 2016
||Mar 24, 2016Loppunut
|NMEA visualisation on Raspberry
||I am active involved in boating and NMEA (have look at: [osoite poistettu, kirjaudu sisään nähdäksesi]) and visualizing NMEA data.
NMEA is a language used by navigational instruments on boats in there communication of data which to other devices, boards, pc’s or displays. NMEA data is normally and received send over TCP, UDP, RS232 and RS422.
My idea is to visualize...
||Mar 21, 2016
||Mar 21, 2016Loppunut
|Android app draw polygon/polyline offline and export to shapefile
||I need an Android app. I would like it designed and built. Draw a polygon/polyline manual (point to point) and automatic, offline without internet connection and export to shapefile (shp, shx and dbf). The points of polygon/polyline are from GPS internal or external (bluetooth or USB receiver) using NMEA. After the draw is done show perimeter and area.
NOTE: The maximum amount I am will to pay fo...
||Mobile App Development, Android
||Mar 20, 2016
||Mar 20, 2016Loppunut
|ReWrite/Write program for project
||The device is a GPS-APRS beacon that transmits AX.25 UI frames using the MS430 TI microcontroller and the APRSGen program, originally written in Python, was modified to C, in order to format GPS data and other information into a packet and convert it into a bitstream that can be transmitted out as tones.
This was then implemented in the microcontroller code, allowing transmission of real-time G...
||Mar 15, 2016
||Mar 15, 2016Loppunut
||We need a software to update our speed cameras detectors (using NMEA system) with files hosted on a server. We need this software to be multilingual and compatible with Windows and Mac OS.
Our products can be found here: [osoite poistettu, kirjaudu sisään nähdäksesi] and the current software only compatiblle with Windows can be downloaded here: [osoite poistettu, kirjaudu si...
||Feb 29, 2016
||Feb 29, 2016Loppunut