Design a logo the bicycles we are building
- Tila: Closed
- Palkinto: $100
- Vastaanotetut työt: 2
- Voittaja: nehelstudio
My son and I are building our own steel framed bikes. We want a logo for the bicycles and the website documenting the build of our bikes.
The logo will go on to the frame when they get powder coated. (The frames will be powder coated in a colour, the logo is cut out in the colour we want and is stuck in place then a transparent outer powder coat applied.)
The brand name is "Normal Bikes".
Slogan "Normal Bikes for normal people".
We are defining normal people as people just like us!. That means 200 cm+ (6ft5+) tall. So these that us and are larger than can typically be found in cycle shops.
The logo should be as simple as possible.
The logo should be monochromatic. Black (RAL 9005) is the most likely colour, but alternatives could include yellow (RAL 1021) and silver (RAL 7040). This will depend on the final colour of the bikes.
The logo could either have a horizontal or vertical layout and will go one of the tubes of the frame.
The diameter of the tubes dictates the maximum width for a vertical logo is 40 mm and for a horizontal logo a maximum of 40 mm high. The other dimension is less critical since space is not limited along the length of the tubes, it could range from 40 mm up-to 400 mm.
The brand name must be included in the logo, the slogan may or may not be included.
We like the idea of the text being be in the font Futura family, or an open source equivalent. Two reasons for this. One we like the round design, secondly it was designed / is from Frankfurt, and that is where we live. But open to suggestions and your ideas.
Name of the font used for the text, so that I can have our email addresses printed in the same font. The email address will go on the bottom tube, out of normal sight.
“Wonderful design, everything timely and easy. Can't be more pleased than I am. Many thanks.”